News Center

Your current location:Home - About us - News center

Why Fieldbus Installations Need Branch Points Instead of Home-Run Cables

Time:2026-11-17 14:05:56 Hits: 13

Field devices cluster. A pallet transfer station might carry four photoelectric sensors, two valve manifolds and a pair of position switches, all bolted to the same frame within two or three metres of one another. Home-run wiring treats each of them as a separate project: one cable per device, back to a terminal in the cabinet, through its own gland. Ten devices become ten long runs, ten cabinet entries, ten chances for a swapped conductor during commissioning, and a cable bundle that has to be routed, clamped and protected along the whole machine. A fieldbus such as CAN does not require that arrangement. It is a multi-drop bus, where every node taps onto the same pair of signal wires and reads the same traffic, ignoring frames it has no use for. Texas Instruments' physical-layer guidance and NXP's application note both describe this shared-medium model, in which devices connect along a common bus rather than through dedicated point-to-point links. The cable question then changes shape: one trunk still comes into the area, but past that point only short drops are needed from a local junction to each nearby device. A sealed branch device is exactly that junction, letting three device cables leave a single trunk connection without anyone opening a terminal box with a screwdriver. The operational gain is easy to see on a live install. The hard part of fieldbus wiring is getting cable from the cabinet into the machine and protecting it once it is there; doing that once instead of ten times shortens the job and removes a pile of gland work. Later additions get easier as well, because an unused port on the branch is a far simpler answer than another run back to the cabinet.

Link: Hybrid connector E-bike power battery pack energy storageM12-connectorsconnectors-cableM12 connectorM8 connectorM5 connectorsconnectors-cable.com